Factory Reset Guide
Wiki Article
Need to return your Holosun EPS Carry Red Dot to its initial settings? It's a straightforward process. First, locate the tiny switch on the side of the sight. Use a fine object like a paperclip to press and hold this switch for approximately ten seconds. You'll see the red dot flash rapidly, indicating the reset process is complete. Release the button and your Holosun EPS Carry Red Dot is now back to factory settings.
- Remember that this will erase any adjusted settings you may have made.
- Check out the official user manual for detailed instructions and specifications.
Returning Your Holosun EPS Carry to Factory Settings
Need find your Holosun EPS Carry back to its factory settings? It's a simple process.
First, identify the setting buttons on the rear of your optic. Then, simultaneously press and sustain both the primary button and the secondary button for around five seconds.
You'll observe a blinking light, indicating that your Holosun EPS Carry is returning. Release the buttons and wait for the display to normalize.
Your Holosun EPS Carry is now back at its factory settings.
Restore Your Holosun EPS Carry
Need to Start fresh? Performing a factory reset on your Holosun EPS Carry optic is a simple process that can optimize its functionality. This will completely erase all custom settings and return the sight to its factory default. Remember, this action is irreversible, so ensure you back up any crucial customizations before proceeding.
- Always confirm
- Familiarize yourself with the reset procedure outlined in your user manual
- Adjust your sight to your preferences
Reset Your Holosun EPS Carry to Defaults: A Step-by-Step Guide
Your Holosun EPS Carry red dot sight is a fantastic tool for self-defense or range time. But rarely, you might need to take it back to its factory settings. This can be beneficial if you're experiencing difficulties with your sight, or just want a fresh start. Thankfully, Holosun made the process of resetting your EPS Carry incredibly easy. Here's a step-by-step guide to help you get started.
- Begin by powering off your Holosun EPS Carry. This is important because any changes made while the sight is on won't be stored.
- After that, locate the small reset button on the rear of your sight. It's usually covered by a rubber cap for protection.
- Employing a thin object like a paperclip or a pen, gently press and hold the reset button for about 5 seconds. You should notice a change in the display, indicating that the sight is resetting.
- Release the reset button and wait for your Holosun EPS Carry to power on. Your sight will now be back to its factory settings.
You did it!
Get Your Holosun EPS Carry Running Again: Factory Reset Guide
Is your trusty Holosun EPS Carry acting up? Don't fret! A factory reset could be just the ticket to bring back its former glory. This simple procedure will clear all user settings and configurations, returning your red dot sight click here to its default state.
Here's how to perform a factory reset on your Holosun EPS Carry:
- Make sure your Holosun EPS Carry is powered off.
- Hold down both the mode button and the power switch for approximately 5 seconds. You'll know it's working when the LED flashes rapidly.
- Let go of both buttons once the LED starts to indicate a successful reset.
- It's ready to use now set to its factory defaults. You can set up your sights as desired.
Let me know if you have any other questions about your Holosun EPS Carry or need help with any other settings!
Reset Your Holosun EPS Carry Red Dot Quickly
To perform a factory reset on your Holosun EPS Carry Red Dot, you'll need to access the menu panel. Using a small tool, press and maintain pressure on the reinitialize lever for about 5 seconds. You'll observe a blink in the display. This indicates that the reset process is successful. Your Holosun EPS Carry Red Dot will now be set to its factory configurations.
- Verify your battery is functioning correctly
- Refer to the user instructions for specific instructions